Publicité
Les langues disponibles
Les langues disponibles
AS-6030
| ENGLISH
Connection example 2:
In exhaust air units with blowing speed controls, the receiver
is connected in series to the fan motor supply to enable
the lighting to function independently of the status of the
receiver. If applicable, the fan motor cable must be led from
the extractor hood housing if the housing overly shields the
transmitter signal and the range is insufficient.
Note: The receiver should not be mounted behind a metal
covering because this can limit the range.
OPERATION
Programming
When operating the device for the first time, it must be
programmed. To do this, proceed as follows:
Note: Please first program the window contact(s) and then
the thermal sensor.
Window contact
1) Power the receiver (1).
2) Press and hold the test button (5) on the receiver until
the LED (3) lights orange continuously. Release the test
button.
3) Insert the CR 123A battery into the window contact
(observe correct polarity) and hold the magnet to the
window contact. The LED (6.1) on the window contact
and the LED (3, red) on the receiver should flash briefly.
4) Complete the programming process by briefly pressing
the test button of the receiver once.
Once the magnet is over 7 mm from the window
AS-6030_I-Manual_150x180_Fin1.indd 18
contact, the receiver should provide the connected device
with electricity. If the magnet is then brought back closer
to the window contact, power is shut off to the device
again. If this does not happen, repeat the procedure.
Note: Up to three window contacts can be programmed
at one receiver. In this case, the window contacts are
co-dependent, i.e., each transmitter must receive the „open
window" status before the receiver turns on the power. This
is useful, for example, if there is a conservatory behind the
window being monitored or if you want to use the tilt and
pivot function.
Carry out steps one to 4 for each additional
window contact.
Thermal sensor
1) Remove the batteries from the transmitter module (8) if
they have already been inserted.
2) Power the receiver.
3) Press and hold the test button (5) on the receiver until
the LED (3) lights orange continuously. Release the
test button.
4) Now put the batteries back in the transmitter module,
paying attention to the polarity of the batteries.
5) The LED (3, green) will blink once.
6) Briefly press the test button once to leave
programming mode.
7) Now wait approx. five minutes, or press the program-
ming button (11) on the transmitter for approx.
two seconds.
Now the device is ready.
18
27.08.13 16:42
Publicité
