Publicité
Les langues disponibles
Les langues disponibles
English
6. Use the hex wrench to turn the blade clamping screw
counter-clockwise to remove.
24
7. Remove the outer flange
the new blade on the inner flange
8. Replace the outer flange
24
. Turn the screw clockwise by hand.
nOTE: The direction of rotation of the saw blade and the
rotation of the track saw MUST be the same.
9. Tighten the blade clamping screw firmly using the
hex wrench.
10. Release and turn the spindle lock lever
clockwise until it stops.
11. Move the track saw back to top position.
12. Push the plunge trigger
1
of blade change mode.
Fig. E
26
21
25
24
10
22
21
5/64"-1/8"
5/64"-1/8"
(2–3 mm)
(2–3 mm)
Adjusting the Riving Knife (Fig. A1, D, E)
For the correct adjustment of the riving knife
to Figure E. Adjust the clearance of the riving knife after
changing the saw blade or whenever necessary.
1. Follow Changing the Saw Blade steps 1–5.
10
25
and used blade
10
. Place
.
26
25
and blade clamping screw
counter-
13
forward, to take the saw out
23
21
, refer
2. Loosen the riving knife adjustment screw
wrench and set the riving knife as shown in Figure E.
3. Tighten the riving knife adjustment screw
4. Turn the spindle lock lever
it stops.
5. Move the track saw back to top position.
6. Push the plunge trigger
1
of blade change mode.
Depth of Cut Adjustment (Fig. F)
The cutting depth can be set at 0–2.3" (0–59 mm) without
guide rail attached; with the guide rail attached: 0–2.2"
(0–55 mm).
1. Loosen the depth adjustment knob
pointer to obtain the correct depth of cut.
2. Tighten the depth adjustment knob
nOTE: For optimal results, allow the saw blade to protrude
from the workpiece by about 1/8" (3 mm) (Fig. F).
Fig. F
8
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. A1)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
14
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
15
handle. Insert it into the charger as described in the charger
section of this manual.
22
with a hex
22
.
counter-clockwise until
13
forward, to take the saw out
8
and move the
.
8
4
into the tool handle, align the
Publicité
