Palmer PDI05 Manuel D'utilisation page 6

SAMPLE APPLICATIONS: A AND B)
FX PREAMP
OR
INPUT 1 INPUT 2
SET SWITCH TO LINE
MIXER
A)
Preamp or effects unit – the most basic application. Connect your preamp
or effects unit to the PDI05. The SPEAKER/LINE switches must be in the
LINE position (= up). For mono units use only one channel of the Speaker
Simulator (yes, you can even plug in your favorite overdrive or distor-
tion pedal). For recording connect the outputs of the speaker simulator
to a mixer or interface. The Headphones output can be used for monitor-
ing. With a PA system or monitor this setup can also be used in live
setups.
B)
Preamp plus effects unit – see A, both preamp and effects unit are used
(SPEAKER/LINE switches in the LINE position = up).
10
OUTPUT 1 OUTPUT 2
INTERFACE
OR
SAMPLE APPLICATION: C)
PREAMP
POWERAMP
INPUT
SET SWITCH
TO SPEAKER
CABINET
Preamp plus power amp (power amp pre-PDI05) – this setup includes power
amp distortion in the filtering process. The SPEAKER/LINE switch must be
in the SPEAKER position (= down), and appropriate loudspeakers or dummy
loads must be connected to the THRU sockets! The PDI05's outputs are fed
to the studio or FOH console.
MIXER
OR
INTERFACE
OUTPUT
THRU
LOADBOX
OR
SIGNAL
PRESENT
SIGNAL
PRESENT
INPUT 2
INPUT 1
11