Contents Of Delivery; Transport And Start Up; Transport And Installation; Assembly - Jet 4224B Mode D'emploi

The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
4.4 Content of delivery
Casting legs with levelling pads
350 mm tool rest
75 mm face plate
Spur centre and tooling knockout bar
Live centre
Guard
Comparator centres
Tool caddy
Vacuum adaptor and support bracket
Vacuum chuck
Air blow gun with house
Remote ON/OFF switch
Operating tools
Assembly kit
Operating manual
Spare parts list.

Fig 2

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and must
be placed stable on firm and levelled ground.
The machine can be bolted down if required.
For packing reasons the machine is not completely assembled

5.2 Assembly

If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Attach the leg stand:
At this point the headstock, tailstock and tool rest should be
removed.
The machine is heavy! Get the help of a second person.
Loosen both headstock cams (A, Fig 3) with provided wrench
to position the head along the lathe bed.
Remove the stop pin (B) to slide the headstock off the bed.
Carefully turn bed upside down on skid. Make sure nothing is
beneath that would scratch the bed ways. Prevent damage to
the JET-Logo plate.
Attach the leg stand with 8 hex socket cap screws, lock
washers and flat washers (A, Fig 4-1).
Fig 3
Fig 4-1