Fig - Jet 4224B Mode D'emploi

Install levelling feet and tighten nuts against the leg (Fig 4-2).
Turn bed upside down.
Adjust the feet so that the lathe rests evenly on the floor.
Reinstall headstock, tool rest and tailstock.
Note:
If installing the 508mm bed extension Kit (#6294900E,
optional), the right leg and bed end surfaces must be flush.
If you are bolting the lathe to the floor, you need to block up
the legs by 40mm to allow sufficient clearance for the
elevating post.
Tool caddy assembly:
Mount the tool caddy with two screws and lock washers to the
left leg (Fig 5)
Note:
The tailstock body can also be used to store tools (Fig 6).

Fig 4-2

Fig 5
Stand shelf:
You can install an extra shelf that rests between the legs if
you wish.
There are different possibilities (see Fig 7-1 to 7-3).
Optical comparator assembly:
Mount the comparator brackets (C and D, Fig 10) to the back
of the headstock and tailstock with socket head cap screws
and lock washers.
Fig 6
Fig 7-1
Fig 7-2
Fig 7-3