Technical Data; Noise Emission; Contents Of Delivery; Transport And Start Up - Jet JWL-1840EVS Mode D'emploi

R Tool caddy with tools
S Casting stands
T...Riser block
U...Remote OFF-switch

4.2 Technical data

Swing over bed
Centre distance
Number of mechanical speeds
Spindle speed range 1
Spindle speed range 2
Spindle nose
Headstock spindle taper
Headstock spindle bore
Spindle index lock
Headstock-Rotation
Tailstock spindle taper
Tailstock bore
Tailstock ram travel
Centre above floor without riser
Centre above floor with riser
Overall (LxWxH)
Net weight
Mains
Output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection
Protection class

4.3 Noise emission

Acoustic pressure level (according to EN ISO 11202):
Idling
In operation
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards
and risks involved only.
4.4 Content of delivery
Lathe bed with headstock, tool support and tailstock – A
350mm Tool rest – B
Legs – C
Spur centre – D
Live centre – E
Live centre with cone – F
Live centre pin – G
Knockout rod – H
75mm Faceplate – J (installed on lathe)
Tool rest extension – K
Faceplate wrench – L
Levellers – M
470mm
1025 & 970mm
2
40-1200 rpm
100-3200 rpm
M33x3.5 DIN 800
MT 2
9.5 mm
36 x 10°
0°, 30°, 60°, 90°,
120°, 180°, 270
MT 2
9 mm
108mm
1000mm
1100mm
1854 x 508 x 1334 mm
190 kg
1~230V, PE, 50Hz
1.5 kW (2 HP) S1
8 A
3x1.5mm²
16A
I
LpA 72.5 dB(A)
LpA 78.4 dB(A)
Tool shelf – N
Riser block – P
Socket hd. cap screws, 5/16"x1-1/4" – HP001*
8x
Lock washers, 5/16" – HP002*
8x
Flat washers, 5/16" – HP003*
8x
Socket hd. cap screws, 3/8"x1-1/4" – HP004
2x
Lock washers, 3/8" – HP005
6x
Hex cap screw, 3/4" x 1-1/4" – HP006
4x
Flat washers, 3/8" – HP007*
4x
User manual
Parts list
* included in hardware package JWL1440-HP1

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted to the floor if required.
For packing reasons the machine is not completely
assembled.
Fig 2