Contents Of Delivery; Transport And Start Up; Transport And Installation; Assembly - Jet JWL-2035-M Mode D'emploi

4.3 Content of delivery
Casting legs with levelling pads
350 mm tool rest
75 mm face plate
Spur centre and tooling knockout bar
Live centre
Guard
Tool caddy
Comparator centres,Has not included in JWL-2020-M lathe,
(S & T, Fig 1)
Remote ON/OFF switch
Operating tools
Assembly kit
Operating manual
Spare parts list.

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
Fig 1
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled

5.2 Assembly

If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Attach the leg stand:
At this point the headstock, tailstock and tool rest should be
removed.
The machine bed is heavy! With the help of a second person,
carefully lift bed up onto a workbench.
Attach the leg stand with 8 hex socket cap screws and 8 flat
washers (A, Fig 2).
Thread adjustable feet (D) into stand leg (B).
Adjust the feet so that the lathe rests evenly on the floor, and
tighten the nuts (C).
Reinstall headstock, tailstock and tool rest.
Tool caddy assembly:
Mount the tool caddy with two screws and lock washers to the
left leg (Fig 3)
Fig 2
Fig 3