Technical Data; Noise Emission; Contents Of Delivery; Transport And Start Up - Jet JWL-2442-M Mode D'emploi

4.2 Technical data

Swing over bed
Swing over tool rest base
Centre distance (JWL-2442-M)
Centre distance (JWL-2424-M)
Number of mechanical speeds
Spindle speed range L
Spindle speed range M
Spindle speed range H
Spindle nose
Headstock spindle taper
Spindle index lock
Spindle hole diameter
Tailstock spindle taper
Tailstock hole diameter
Tailstock ram travel
Centre above floor
Overall for JWL-2442-M (LxWxH)
Overall for JWL-2424-M (LxWxH)
Leg footprint for JWL-2442-M (LxW)
Leg footprint for JWL-2424-M (LxW)
Net weight for JWL-2442-M
Net weight for JWL-2424-M
Mains
Output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection
Isolation class
Compressed air supply

4.3 Noise emission

Acoustic pressure level (according to EN ISO 11202):
Idling
In operation
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended
to allow the user to make a better estimation of the
hazards and risks involved only.
4.4 Content of delivery
Casting legs with levelling pads
350 mm tool rest
75 mm face plate
Spur centre and tooling knockout bar
Live centre
Guard
Comparator centres
Tool caddy
Vacuum adaptor and support bracket
Vacuum chuck
Air blow gun with house
610mm
490mm
1067mm
609mm
3
0 - 910 rpm
0 - 2000 rpm
0 - 3500 rpm
M33x3.5 DIN 800
MT 2
14x25.7°, 36x10°, 48x7.5°
15.8mm
MT 2
9.5mm
115mm
1120mm
2260x710x1651mm
1802x710x1651mm
1600x610mm
1140x610mm
395 kg
350 kg
1~230V, PE, 50Hz
2.2 kW (3 HP) S1
12 A
3x1.5mm²
16A
6.5bar (90psi)
LpA 72.5 dB(A)
LpA 78.4 dB(A)
Remote ON/OFF switch
Operating tools
Assembly kit
Operating manual
Spare parts list.
I

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled

5.2 Assembly

If you notice transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent.
Attach the leg stand:
At this point the headstock, tailstock and tool rest should
be removed.
Fig 2