Assembly - Husqvarna 436 Li Manuel D'utilisation

To assemble the guide bar and saw
chain (436 Li)
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the knob and remove the drive sprocket
cover (chain brake) and the transportation ring (A).
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
5. Make sure that the edges of the cutting links face
forward on the top edge of the guide bar.
481 - 001 - 22.01.2018

Assembly

6. Assemble the drive sprocket cover and steer the
7. Make sure that the drive links of the saw chain fit
8. Make sure that the saw chain is correctly engaged in
9. Tighten the saw chain. See
To assemble the guide bar and saw
chain (536 LiXP)
1. Disengage the chain brake.
2. Loosen the bar nut and remove the drive sprocket
A
3. Put the guide bar on top of the bar bolt. Steer the
chain adjuster pin to the hole in the guide bar.
correctly on the drive sprocket.
the groove in the guide bar.
on page 28 for instructions.
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
cover and the transportation ring (A).
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
To tighten the saw chain
A
13