Husqvarna 436 Li Manuel D'utilisation page 35

Association Z62.1-11 (Chain saws) and Z62.3-11 (Chain
Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated
and listed as a Type C Low Kickback Saw chain
according to the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
Guide bar
Length, in Chain pitch, in
10 3/8
12
14
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
11/64 in/4,5
38
mm
Approved batteries for the product
Battery
Type
Battery capacity, Ah
Nominal voltage, V
Weight, kg/lb
481 - 001 - 22.01.2018
Gauge, in
0.043
90° 30°
BLi110
Lithium-ion
3,0
36
1,2/2.6
As we are listing the maximum guide bar nose radius,
you may use a guide bar with smaller nose radius than
in our list. For guide bars of the same length, all
sprocket-nose guide bars of the same pitch and having
the same number of sprocket teeth may be considered
to have equivalent kickback energy.
The following cutting equipment is approved for the
models Husqvarna436 Li and 536 LiXP.
Saw chain
Max. nose radius Type
7T Husqvarna H38
9T
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
0.025 in/
0°
0,65 mm
BLi150
Lithium-ion
4,2
36
1,3/2.9
Length, drive
links (no.)
40
45
52
5056981-03 5795588-01
35