Publicité
Les langues disponibles
Les langues disponibles
EN-7
6.0 MAINTENANCE
6.1 Troubleshooting
Symptom
Cannot turn on
Poor accuracy
Cannot calibrate
Cannot access mode Mode not enabled
Cannot access unit
Err 5
Err 7.0
Err 8.1
Err 8.2
Err 8.3
Err 8.4
Err 9.5
Err 9.8
Error 53
REF Err
LOWrEF
6.2 Service Information
If the troubleshooting section does not resolve or describe your problem, contact your authorized Ohaus service
agent. Please visit our web site, www.ohaus.com to locate the Ohaus office nearest you.
6.3 Accessories
Security device
Auxiliary Display
Printer – Thermal
Printer - Impact
Cable Kit - STP-103
Cable Kit - CBM-910
Data collection Software
Ohaus Collect
7. TECHNICAL DATA
Ambient conditions - The technical data is valid under the following ambient conditions:
Ambient temperature: 10° C to 30° C
Relative humidity: 15 % to 80 % at 31° C non-condensing, decreasing linearly to 50% at 40° C
Height above sea level: Up to 2000 m
Operability is assured at ambient temperatures between 5° C and 40° C
Power - AC adapter, Balance power input 8-14.5 VAC, 50/60Hz 4VA or 8-20 VDC, 4W
Protection - Protected against dust and water, Pollution degree: 2, Installation category: Class II
Possible Cause
No power to balance
Improper calibration
Unstable environment
Unstable environment
Incorrect calibration masses
Units not enabled
Average Piece Weight too small
Time out
Pan has load during power on
Pan was removed prior to power on
Weight on pan exceeds capacity
Pan was removed during weighing
Factory calibration data corrupted
Factory calibration data corrupted
EEPROM Checksum error
Reference Weight is too small
Reference Weight is too low for accurate
parts counting or percent weighing
76288-01
PAD7
STP-103
CBM-910 or SRP275
80252581
80252571
SW12
80500746
PAJ-N Series
Remedy
Verify connections and voltage
Perform calibration
Move balance to suitable location
Move the balance to suitable location
Use correct calibration masses
Enter menu and enable mode
Enter menu and enable units
Add additional samples
Remove weight from pan and re-zero
Install pan and re-zero
Remove weight from the pan
Re-install pan
Contact the authorized dealer
Perform calibration
Contact the authorized dealer
Add additional samples
Add additional samples or continue to weigh
with less accurate results
Publicité
