en-us Care and Maintenance
Spray arms
Check spray arms 1:, 1R for
grease and limescale deposits. If you
find such deposits:
Fill detergent dispenser 92 with
■
detergent and start the appliance
without utensils in the cycle with
the highest rinsing temperature.
~ "Wash Cycle Information"
on page 28
Clean the appliance with
■
detergents/appliance cleaners
which are particularly suitable for
use with dishwashers.
Unscrew the upper spray arm
■
1: and pull off the lower spray
1R arm as shown. Inspect for
deposits.
Drain pump
Large food remnants in the rinsing
water not retained by the filters may
block the waste water pump. In this
case:
Disconnect the appliance from the
■
power supply.
Remove the filters. ~ "Filters"
■
on page 34
Scoop out standing water - use a
■
sponge if necessary.
36
Using a spoon, pry off the pump
■
cover until it clicks, then grip the
cover and pull upward until it
resists and then pull forward.
Check inner compartment and
■
remove any foreign objects.
WARNING
9
Use caution when removing
parts for cleaning as some
debris may be sharp.
Place cover in the original
■
position, press down and engage.
Reinstall filters.
■
The drain pump will not work
Note:
properly if the drain pump cover is
not snapped in completely until it
clicks.