Extension Table; Removing The Extension Table; Opening The Accessory Case; Changing The Presser Foot - Singer 9960 Manuel D'utilisation

Table des Matières

Publicité

EXTENSION TABLE

a. REMOVING THE EXTENSION TABLE
Hook your fi nger to the left bottom side of
extension table and slide it to the left. To attach,
insert to the right.
b. OPENING THE ACCESSORY CASE
Hook your fi nger to the left side of accessory
case and pull toward you.
CHANGING THE PRESSER
FOOT
The presser foot must be changed according to
the stitch you sew, or work you do.
CAUTION: To prevent accidents.
Turn off the power switch before you change the
presser foot.
A. Changing the presser foot
1. Turn the hand wheel toward you until the needle
is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser
foot release lever toward you.
4. Place desired foot with its pin directly under the
slot in presser foot holder.
5. Lower the presser foot lifting lever and the
presser foot will snap into place.
B. Removing the presser foot holder
When attaching the special presser foot or
cleaning the machine, you should remove the
presser foot holder.
1. Remove the presser foot.
2. Loosen the presser foot thumb screw and
remove the presser foot holder.
3. To replace the holder, pull up the holder as far
as it will go from bottom of presser bar.
4. Tighten the thumb screw.
14

Publicité

Table des Matières
loading

Table des Matières