Table des Matières
Publicité
F. THREAD CUTTER BUTTON
Press this button after sewing to cut the upper and
bobbin threads.
The machine will cut both threads automatically.
CAUTION
1. Do not press this button when there is no fabric
in the machine or no need to cut the threads.
The thread may tangle, resulting in damage.
2. Do not use this button when cutting thread
thicker than #30, nylon thread or other speciality
threads.
In this case, use the thread cutter (H).
G. DROP FEED LEVER
The fabric feed dogs project up through the needle
plate, directly below the presser foot. Their function
is to move the fabric being sewn. The drop feed
lever controls the fabric feed dogs.
For ordinary sewing, move the lever to the right.
This raises feed dogs to their highest position. For
most sewing, the lever should be in this position.
For darning or free motion embroidery or whenever
fabric is to be moved by hand, move the lever to
the left to lower the fabric feed dogs.
H. THREAD CUTTER
Use this cutter if the thread cutter button is not
used.
1. Raise the presser foot and bring fabric and
threads backward after sewing.
2. Hook the threads to the thread cutter from back
to front.
3. Pull fabric and cut threads.
I. TOP COVER
To open the top cover, lift up the right side of
cover.
J. HAND WHEEL
By turning the hand wheel, the needle will raise or
lower. You should turn hand wheel toward you.
EXTRA WIDE TABLE
If you need wide sewing space, attach the extra
wide table as below.
Set the machine and extra wide table on the stable
table.
1. Remove the extension table (See Page 14)
2. Stand up the two legs of extra wide table.
3. Insert wide table to the machine sliding to the
right.
4. Adjust the height of table by turning the four
rubber feet.
22
Publicité
Table des Matières
