Operating The Motor Sweeper; Perform The Following Checks Before Starting The Motor-Sweeper; Starting The Engine - RCM Brava 800 Manuel D'utilisation Et D'entretien

Perform the following checks before starting the motor-sweeper

• Make sure there is fuel in the tank 1.
• Check the level of the oil in the motor 2.
• Raise the side brush by means of the lever 3.

Starting the engine

Proceed as follows:
• Set the red knob (4) in position"ON".
• Set the levers (5) of the carburator as shown in the picture and on carburator label.
• Set the accellerator lever (6) at the maximum speed (as the arrow in the picture).
• Pull the handle (7) to start engine and sweeper.
• Set the red knob (4) on position "OFF" to stop the engine and sweeper.
4
OPERATING THE MOTOR-SWEEPER (FIG.3)
ON ON
5
OFF OFF
OFF OFF
ON ON
5
7
28
1
2 3
6
OFF OFF
ON ON