Skil PWRCORE 12 ID574401 Guide D'utilisation page 13

Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the trigger.
The variable-speed trigger switch delivers high-
er speed with increased trigger pressure and
lower speed with decreased trigger pressure
(Fig. 4).
Halo Light
Your tool is equipped with a Halo light, located
on the head of the tool, This provides addition-
al light without shadows on the surface of the
work piece for operation in lower-light areas.
The Halo light will automatically turn on with
a slight squeeze on the variable-speed trig-
ger switch before the tool starts running, and
will turn off 8 to 12 seconds after the vari-
able-speed trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the halo light will flash rapidly.
Rest the tool for a while or place the tool and
battery pack separately under air flow to cool.
The Halo light will flash more slowly to indicate that the battery is at low-battery capacity, Re-
charge the battery pack.
Mode Selector
Your tool is equipped with a speed-adjusting
interface to provide speed adjustment for 2
modes (low/high).
When the trigger is squeezed slightly, the
mode indicator will automatically shine green.
Depress the mode selector to adjust the speed
mode (Fig. 6).
One indicator light shines for "L" to indicate
"low-speed mode".
Both indicator lights shine for "H" to indicate
"high-speed mode".
Fig. 4
Variable Speed
Trigger Switch
Fig. 5
Halo Light
Fig. 6
Mode Selector Mode Indicator
13