Skil PWRCORE 12 ID574401 Guide D'utilisation page 12

NOTICE:
When placing the battery pack in the tool, be sure that the raised rib on battery pack
aligns with the groove inside the tool and that the latches snap into place properly. Improper
attachment of the battery pack can cause damage to internal components.
WARNING
be locked in center position when not in use or carrying at your side.
Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector
WARNING
Your tool is equipped with a direction-of-rotation selector located above the trigger switch. This
selector is designed for changing the direction of rotation of the bit and for locking the trigger
in the "OFF" (center-lock) position.
a. Position the direction-of-rotation selector to the far left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the far right of the tool for reverse rotation.
c. Setting the switch in "OFF" (center-lock) position helps to reduce the possibility of accidental
starting when not in use (Fig. 3).
NOTICE: To prevent gear damage, always allow the impact driver to come to a complete stop
before changing the direction of rotation.
NOTICE: The impact driver will not run unless the direction-of-rotation selector is engaged
fully to the left or right.
Fig. 3
Center-Lock
12
Battery tools are always in operating condition. Therefore, the Direc-
tion-of-Rotation (forward/center-lock/reverse) Selector should always
After tool use, lock the direction-of-rotation selector in the "OFF"
position (center-lock) to help prevent accidental starts and injury.
Forward Reverse