ECOFOREST ECO III Manuel D'installation Et Maintenance page 45

It is recommendable to calculate the frequency with which you clean the outlet cleaning considering the
hours of operation, thus avoiding ash saturation.
Once you clean the walls of the stove, you must be sure that the cleaning outlet is securely closed, since the
proper operation of the stove depends on this cleaning.
5.6. Top plate of the fireplace. Bolonia model.
You have to push up the top plate of the fireplace (
plate and pull it. When finished, put back the top plate being sure that the tabs are properly seated.

5.7. Empty the hopper to take remaining pellets out to avoid pellets absorb humidity.
5.8. Cleaning of the pellets drop tube.
Use the brush provided by ECOFOREST to remove the dust until the end of the tube.

Cleaning brush.

Pipe of pellets fall.
5.9. Cleaning of the exhaust circuit of the stove, extractor's collector.
For an optimal cleaning of the extractor's collector, it is recommended to dismantle the extractor itself in
order to have full access to this zone for a better cleaning. Once the extractor is dismantled, clean it with a
dry brush and be careful with the turbine and structure.
The following drawing illustrates model Eco III. What differentiates this stove from the rest is the position of
the extractor.

Gas outlet extractor.

Ceramic fiber joint (replace).
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.

), to disengage the tabs which secure it to the center

Drawing 33
44
Drawing 34
Drawing 35