∙ Only use the device for food preparation
∙ Never use the device after a malfunction, e.g. when it was fal-
len down or was damaged in any way.
∙ To avoid any dangers must repairs, e.g. change of a defect po-
wer cord, only be done by our service or an authorised compa-
ny.
∙ Device gets hot. Only transport after it cooled down.
∙ If the appliance is used as a table top, it must be placed on a
even, stable and heat resisting surface (e.g. Not on painted fur-
niture) and keep away (min 70cm) of burnable materials (e.g.
curtains)
∙ Before the first use: Clean all parts and dry them afterwards. To
eliminate the smell of the new item, heat it up for ca. 15min.
The device can smoke a little bit at the beginning.
∙
Attention!
Housing get hot.
Danger of burns!
∙ The appliance should be supplied through a residual current
device (RCD) having a rated residual operating current not ex-
ceeding 30mA.
∙ The connector shall be removed before the appliance is cleaned
and that the appliance inlet must be dried before the appliance
is used again.
Safety requirements during usage:
∙ Only use the appliance at a safety plug socket. This should be
connected to a earth leakage circuit breaker
∙ Use the appliance only when it is assembled.
∙ Do not use the grill plate outside of the appliance and never
immerse into water.
∙ Never leave the appliance outdoors after usage.
∙ Fat and other grill food can spatter and drop. Therefore do not
place the appliance not directly on sensitive surfaces, e.g. Polis-
hed table tops, parquet or carpet.
10