Maintenance - Haussmann Xpert MJ10250IXC Guide D'utilisation

!
!
!
4
5
6
fig.38

MAINTENANCE

CAUTION! For your own safety, turn the switch OFF and remove the key. Remove
the plug from the power source before maintaining or lubricating your saw.
GENERAL MAINTENANCE
Clean out all sawdust that has accumulated inside the saw base and around the
motor. Polish the saw table with an automotive wax in order to keep it clean and
to make it easier to slide the workpiece. Clean the cutting blades with pitch and
gum remover. Immediately replace a worn, cut, or damaged power cord.
CAUTION! All electrical and mechanical repairs should be performed by a qualified
repair technician. Use only identical replacement parts. Any substitute parts may
create a hazard. Use liquid dish washing detergent and water to clean all plastic
parts.
NOTE: The use of certain cleaning chemicals may damage plastic parts. Do not
use the following cleaning chemicals or solvents on your table saw: gasoline,
carbon tetrachloride, chlorinated solvents, ammonia, and household detergents
that contain ammonia.
BLADE RAISING MECHANISM (FIG. 38)
The blade raising mechanisms should be checked for looseness, binding, or other
abnormalities after every five hours of operation. Disconnect the table saw from
the power source and turn it upside down, and then alternately pull upward and
3
downward on the motor on the motor unit. Observe any movement in the motor
mounting mechanism. (See Fig. 38)
2
• Turn the screw pole (1) in the fixed part (2) connection with the wheel.
• The power will be transferred by the tapered gear (3) and screw pole (4).
• The pole (6) in the fixed part (5) will be moved up and down.
Place a small amount of dry lubricant, such as graphite or silicone, on the screw
rod at the thrust washer. Do not oil the threads of the screw rod. For smooth
1
operation, the screw rod must be kept clean and free of sawdust, gum, pitch, and
other contaminants. Wet lubricants such as oil will attract sawdust, etc. If excessive
looseness is observed in any other part of the blade raising or tilting mechanisms,
please contact Customer service at 1-866-206-0888.
LUBRICATION
All motor bearing are permanently lubricated at the factory, and do not require any
additional lubrication. Lubricate all mechanical parts of your table saw where a
pivot or threaded rod is present with graphite or silicone. These dry lubricants will
not hold sawdust like oil or grease will.
53