Haussmann Xpert MJ10250IXC Guide D'utilisation page 42

!
1
fig.7
4
5
6
fig.8
!
7
fig.9
!
ASSEMBLY AND ADJUSTMENTS
NOTE : Keep this manual as reference for future blade changes.
• Remove the table insert (1) by inserting the finger into the hole (2) (see Fig. 7).
• Raise the saw blade arbor (3) to its maximum height by turning the blade raising
hand wheel counter-clockwise. Remove the arbor nut (4) and the outer flange (5)
from the saw arbor. (see Fig. 8)
• Place the saw blade on the arbor, making sure the teeth of the blade point DOWN
at the front of the table.
• Place the flange (5) and the arbor nut (4) on the arbor, and tighten the nut as far
as possible by hand, making sure the saw blade is firmly seated against the inner
flange (6) (see Fig. 8).
2
3
NOTE : Make sure the large flat surfaces of the flange and the nut face INWARD,
toward the saw blade.
• Place the jaws of the open-ended wrench (7) on the flats of the flange (5) in order
to prevent the arbor from turning while tightening. Tighten the arbor nut by turning
it clockwise using the open-ended wrench (7) (See Fig. 9).
WARNING: Make sure the saw blade, arbor flange, and nut are properly seated,
and verify that the arbor nut is tight.
41