Haussmann Xpert MJ10250IXC Guide D'utilisation page 44

!
fig.14-a
fig.14-b
fig.15-a
fig.15-b
fig.16
ASSEMBLY AND ADJUSTMENTS
INSTALLING THE ANTI-KICKBACK PAWLS AND BLADE GUARD (Fig. 14-17)
NOTE : Anti-kickback pawls should only be installed for through cuts.
• Unplug the saw.
• Raise the saw blade.
• Place the rivng knife in "up" position.
TO INSTALL ANTI-KICKBACK PAWLS:
• Installing the anti-kickback pawls on the riving knife as shown (Fig. 14-a), the pin
on the anti-kickback pawls is inserted in the slot of riving knife.
• Lock the handle as shown in the (Fig. 14-b).
TO INSTALL BLADE GUARD:
• Installing the blade gurard on the riving knife as shown (Fig. 15-a), the pin on the
blade guard base should match with the slot on the riving knife as show (Fig. 15-b).
• Then tighting the handle as shown (Fig. 16), the blade guard should be parallel
with the worktable (Fig. 17). If the blade guard is not parallel, the riving knife is
not in "up" position.
fig.17
43