Prior To First Use; Unpacking The Items Supplied; Charging The Battery; Assembling The Appliance - DS Produkte Z 07146 Mode D'emploi

Prior to First Use

Before using the appliance you have to:
• unpack the items supplied,
• charge the battery,
• assemble the appliance.

Unpacking the Items Supplied

ATTENTION!
❐ Risk of suffocation! Keep the packaging material away from children and animals.
Unpack all parts and check the scope of supply for completeness (see the "Scope of
Supply and Overview of the Appliance" chapter); also check for transport damage. If
you fi nd any damage to the components, do not use them (!), but contact the customer
service department.

Charging the Battery

CAUTION!
❐ Do not leave the battery in the charger for more than 24 hours as otherwise its lifetime
will be shortened.
Before initial use, and when the appliance is no longer as powerful as it was, the battery
has to be recharged.
3. Allow the battery to charge up completely. The battery needs approximately 8 hours
to charge up for initial use. The length of time required for subsequent recharging
depends on the charging status of the battery in each case; if the battery is fl at it is
approximately 5 hours.
4. Then remove the charger from the socket and take out the battery. In order to do this,
press the two side locking tabs on the battery together and pull the battery out.

Assembling the Appliance

1. Insert the lower part of the bar into the bar of the cleaning foot. Make sure, that the
arrows on the two parts are pointing at each other. When pushing the two parts
together, press the two locking tabs on the bar of the cleaning foot together. The tabs
then have to lock into place in the openings of the lower part of the bar.
2. Then, screw the middle part of the bar on the lower part and the upper part of the bar
on the middle part.
1. Insert the battery into the charger, till it clicks
audibly into place. You can only insert the battery
in one way direction into the charger (arrows
pointing at each other; see illustration).
2. Connect the charger to an accessible, properly
installed mains socket with the corresponding
technical data (see the "Technical Data" chapter).
17