Haussmann MJ2625VIA Guide De L'utilisateur page 42

Pointer
Mitre scale
fig.20
Lever
Mitre scale
Workpiece
fig.21
Lever
Mitre scale
Workpiece
fig.22
Groove
fig.23
OPERATION
If you perform the slide cut without pulling the carriage fully or if you perform the
Knob
slide cut towards you, the blade may kickback unexpectedly with the potential to
cause SERIOUS PERSONAL INJURY.
Never perform the slide cut with the handle locked in the lowered position by
pressing the stop pin.
MITRE CUTTING (fig. 20)
Loosen the knob by turning counterclockwise. When you have moved the knob to
the position where the pointer points to the desired angle on the mitre scale, securely
tighten the grip clockwise.
CAUTION: When turning the rotary table, be sure to raise the handle fully. After
changing the mitre angle, always secure the rotary table by tightening the knob firmly.
BEVEL CUTTING (fig. 21)
Loosen the lever and tilt the saw blade to set the bevel angle (refer to the previously
covered " Adjusting the bevel angle").
Be sure to retighten the lever firmly to secure the selected bevel angle safely.
Secure the workpiece with a clamp. Make sure the carriage is pulled all the way
back toward the operator fully. Switch on the tool without the blade making any
contact and wait until the blade attains full speed. Then gently lower the handle to
the fully lowered position while applying pressure in parallel with the blade and
PUSH THE CARRIAGE TOWARD THE GUIDE FENCE TO CUT THE WORKPIECE.
When the cut is completed, switch off the tool and WAIT UNTIL THE BLADE HAS
COME TO A COMPLETES STOP before returning the blade to its fully elevated
position.
CAUTION: Always be sure that the blade will move down to bevel direction
during a bevel cut. Keep your hands out of path of the saw blade. During a
bevel cut, it may create a condition whereby the piece cut off will come to rest
against the side of the blade. If the blade is raised while the blade is still
rotating, this piece may be caught by the blade, causing fragments to be
scattered, which is dangerous. The blade should be raised ONLY after the blade
has come to a complete stop.
When pressing down the handle, apply pressure in parallel with the blade. If a
force is applied perpendicularly to the rotary table or if the pressure direction is
changed during a cut, the precision of the cut will be diminished. Always slide
or remove the sliding fence (left) so that it does not interfere with any part of
the carriage when performing bevel cuts.
COMPOUND CUTTING (fig. 22)
Compound cutting is the process in which a bevel angle is made at the same time
in which a mitre angle is being cut on a workpiece.
Compound cutting can be performed at the angles shown in the table.
Left and Right 0
When performing compound cutting, refer to the "Press cutting", "Slide cutting",
"Mitre cutting" and "Bevel cutting" sections.
GROOVE CUTTING (fig. 23)
A dado type cut can be made by proceeding as follows: Adjust the lower limit
position of the blade using the adjusting screw and the stopper arm to limit the
cutting depth of the blade. Refer to the "Stopper arm" section described previously.
After adjusting the lower limit position of the blade, cut parallel grooves across the
width of the workpiece using a slide (push) cut as shown in the figure. Then remove
the workpiece material between the grooves with a chisel.
Do not attempt to perform this type of cut using wide (thick) blades or with a dado
blade. Possible loss of control and injury may result.
Mitre angle
~45
o o
Bevel angle
Left 0 ~45
o o
41