Haussmann MJ2625VIA Guide De L'utilisateur page 40

Locking knob
fig.13
fig.14
Screw
Clamp knob
Clamp arm
Guide fence
Clamp rod
fig.15
Knob
Base
fig.16
Right extension table
ASSEMBLY AND ADJUSTMENTS
SLIDING SUB FENCE ADJUSTMENT (fig. 13 & 14)
• Before bevel cutting, make sure that no part of the tool contacts the sliding fence
when lowering and raising the handle fully at any position and pulling or pushing
the carriage all the way at the lowest position.
• Before operating the tool, make sure that the sliding fence is secured by the
locking knob firmly.
• When performing bevel cuts, slide out the sliding fence and secure it as shown
in the figure. 14. Otherwise, it will contact the blade or a part of the tool, causing
possible serious injury to the operator.
MOUNTING THE VERTICAL CLAMP (fig. 15)
• The vertical clamp can be installed on either the left or right side of the guide fence.
Insert the vise rod into the hole in the guide fence.
• Position the clamp arm according to the thickness and shape of the workpiece and
secure the clamp arm by tightening the screw. If the clamp arm contacts the guide
fence or sub-fence, adjust the clamp arm to the upper position.
• Make sure that no part of the tool contacts the clamp when lowering the handle fully
and pulling or pushing the carriage all the way. If some part contacts the clamp,
re-position the clamp.
• Press the workpiece flat against the guide fence and the rotary table. Position the
workpiece at the desired cutting position and secure it firmly by tightening the vise
knob.
NOTE: The workpiece must be secured firmly against the rotary table and guide fence
with the clamp during all operations.
EXTENSION TABLE ADJUSTMENT (fig. 16)
• Unlock the knob on the base. Slide the right extension table to the desired table
width and stop the extension table by locking the knobs.
• Slide the left extension table by the same amount as above.
39