Auto Setup Faq - Kicker KEY200.4 Manuel D'utilisation

Auto Setup FAQ

Q: How silent must the ambient noise be in order for
the Auto Setup work properly?
A: As silent as possible, both inside and outside the
vehicle. The HVAC should be off and the windows
rolled up, with as few obstructions in the vehicle as
possible. Lower frequency noises interfere more than
higher frequency noises. In case the ambient noise is
too much, the Auto Setup program will quit with sad
music and error code #6.
Q: Can I put more than one KEY amplifier in my car?
A: Yes, however the Auto Setup program is designed
to optimize the front-sound stage only. Only one KEY
amplifier can use the Auto Setup feature.
Q: Can I use the KEY amplifier in addition to a
subwoofer?
A: Yes, but care must be taken. Make sure you
disconnect your subwoofer prior to the Auto Setup
process. The subwoofer must stay quiet during the
Auto Setup so the KEY amp can hear what the car
speakers sound like without interference.
Upon successful completion of the Auto Setup, you
can reconnect your subwoofer and use the crossover
switches on the KEY amplifier to apply an adequate
hi-pass to your speakers in order to match them with
your subwoofer. If you've forgotten to disconnect your
subwoofer and it plays pink noise during Auto Setup,
the Auto Setup program will quit with sad music and
error code #6.
Q: How does the Crossover work on the KEY amp?
A: In case no Auto Setup has been done, or the
Auto Setup process was for Full-Range speakers
(most cases), the 24dB/octave Linkwitz-Riley Hi-
English 17