Kicker KEY200.4 Manuel D'utilisation page 18

pass crossover will be applied to all speakers. This
crossover is user-selectable via DIP switches with the
following options: OFF, 60 Hz, 80 Hz or 120 Hz.
In case of a Bi-Amp system with woofers and
tweeters, the door speaker's hi-pass is user
selectable and the lo-pass is 3.2 kHz 24 dB/octave.
The tweeter's hi-pass is also 3.2 kHz 24db/octave.
In case of a Bi-Amp system with door and dash
woofers, the door woofer's hi-pass is user selectable
and the low-pass is 640 Hz 24 dB/octave. The dash
woofer's hi-pass is 320 Hz 24db/octave. The overlap
of 640 Hz low-pass with 320 Hz hi-pass is done on
purpose to enrich the mid-range. The Auto EQ takes
care of trimming excesses that can occur within this
range.
Q: My Auto Setup program did not complete
successfully, I am getting a sad song and beeps at
the end. What is it?
A: The beeps at the end are the error codes of the
Auto Setup program. Upon failure, please count the
number of beeps after the sad song and troubleshoot
with the information below.
Q: The Auto Setup process completed successfully,
but I'm not happy with the sound. What other steps
can I take?
A: Ensure all speakers connected to the KEY amplifier
are wired in phase with each other. Be sure to check
both the amplifier side and the speaker side of the
wiring.
Visit www.kicker.com/tech to download the pink noise
profile best suited for your listening habits!
English 18