Kicker KEY200.4 Manuel D'utilisation page 16

5. Begin the Auto Setup by quick-pressing the KEY
Activation Button. Once initialized, you will hear
repeating tones (beeps), which indicate that you must
exit the vehicle and close the door. You will have 10
seconds until the process begins. Beeps and noises
during the KEY Auto Setup process can be loud. For
your safety, please do not remain inside the vehicle!
KEY Activation Button
6. Once the Auto Setup has completed, you will hear
happy music for a successful setup. You may quick-
press the KEY Activation Button to toggle between
the original, non-optimized audio or re-apply the KEY
optimized audio. Dial in the GAIN settings and you're
done!
Upon successful completion, if you wish to clear
the Auto Setup settings and revert the KEY amp to
"clean", press and hold the KEY Activation Button for
10 seconds. You will hear a single long beep. You
can then repeat the Auto Setup process if desired.
If the Auto Setup process did not complete
successfully, you will hear sad music, followed by
beeps that represent an error code. Count the
number of beeps, ranging from 1 to 6, and refer to
the Troubleshooting section. Once you've addressed
the cause, you can quick-press the KEY Activation
Button to run the Auto Setup process again.
English 16