Cameo ZENIT W600 D SMD CLZW600DSMD Manuel D'utilisation page 19

Display = Display
Reverse rotation
Display Back- = Display
light lighting
DMX Fail = Operating
status when
DMX signal
fault occurs
Dimmer = Dimmer
Curve curve
Power Mode = Operating
mode
Dimmer = Dimmer
response response
Autolock = Automatic
locking of
controls
PWM Fre- = LED PWM
quency frequency:
On Display is rotated by 180° (e.g. for overhead
installation)
Off No rotation of the display
On permanently on
Off Deactivation after approximately 1 minute of
inactivity
Hold last command is retained
Blackout Activates blackout
Full On Spotlight switches to full on
Stand-alone Spotlight switches to stand-alone mode
Linear Light intensity increases linearly with DMX
value
Exponential Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher
DMX values
Logarithmic Light intensity can be broadly adjusted at low-
er DMX values and finely adjusted at higher
DMX values
S-curve Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted
at medium DMX values
Normal Constant brightness
Boost Brief maximum brightness (approx. 3 seconds)
LED Lamp responds abruptly to changes in DMX
value
Halogen Spotlight behaves like a halogen spotlight with
soft brightness changes
On Automatic locking of the controls after approx-
imately 1 minute of inactivity. After attempted
input the display shows: "Locked!"
Unlock: press and hold UP and DOWN simulta-
neously for approx. 5 seconds
Off Automatic locking of the controls is disabled
800 Hz/1200 Configuration of LED PWM frequency
Hz/2000 Hz/
3600 Hz/12
kHz/25 kHz
19