Cameo ZENIT W600 D SMD CLZW600DSMD Manuel D'utilisation page 13

3 DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console; when not in
use, always close with the rubber sealing cap).
4 DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with
the rubber sealing cap).
5 OLED DISPLAY
The OLED display shows the currently activated mode (main display), the menu items in the
selection menu and the numerical value or status in the various menu items.
6 TOUCH-SENSITIVE CONTROLS
MODE
Press MODE to access the main menu. Press again or repeatedly to return to the main display.
ENTER
Press ENTER to access the menu level to make value or status changes, and to access the sub-
menus. Confirm value or status changes by pressing ENTER.
UP and DOWN
– Select individual menu items in the main menu (DMX address, operating mode etc.) and in the
submenus. Allow changes to the status or value in a menu item, such as the DMX address, as
required.
PRESSURE EQUALISATION ELEMENT
The pressure equalisation element to prevent condensation inside the housing is in the device
base, behind the cable feed for the LED unit. In order to ensure its proper function, the element
must be protected from contamination.
HOUSING FAN
The 3 housing fans and the heat sink are on the back of the LED unit. In order to ensure good air
circulation, do not cover the device and clean it regularly.
PLEASE NOTE
• As soon as the spotlight is connected is supplied with power, the following are displayed in suc-
cession: "Welcome to Cameo", the model name and the software version. During the start-up
process, the previously set operating mode is activated and the spotlight is ready for operation
after a short time.
• Before changing device settings, ensure that the control panel is dry and free of dust in order not
to impair its functionality.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the
13