General Safety Instructions - QEP 60089Q Manuel D'utilisation

GENERAL SAFETY INSTRUCTIONS

Read this owner's manual completely and make sure you understand all of it's safety guidelines.
1. Keep guards in place and in working order.
2. remove adjusting Keys & wrenches. Before turning on the tile saw, make sure the keys and
adjusting wrenches have been removed.
3. Keep worK area clean. Cluttered areas and benches invite accidents.
4. always remain alert when the saw is in use. Inattention on the part of the operator may
lead to serious injury.
5. don't use in a dangerous environment. Don't use power tools in damp or wet locations or
expose them to rain. Keep work area well lit.
6. Keep children away. All visitors should remain at a safe distance from work area.
7. maKe worKshop child-proof with padlocks, master switches or by removing starter keys.
8. use the right tool. Don't force a tool or attachment to do a job for which it was not designed.
9. use the proper eXtension cord. Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and
overheating. Table (see Table 1) shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
10. don't force the tool. It has been designed to operate at maximum safety and performance
levels.
11. do not force the material being cut. Always let the blade cut at its own speed.
12. wear proper apparel. Do not wear loose clothing, neckties, rings, bracelets or other jewelry
which may get caught in moving parts. Non-slip foot wear is recommended. Wear protective hair
covering if you have long hair.
13. always use safety glasses. Also use face or dust mask for commercial cutting operations.
Everyday eyeglasses only have impact-resistant lenses, they are NOT safety glasses.
14. secure worK. Use clamps or a vise instead of your hand to hold work when practical. This
safety precaution allows for proper tool operation using both hands.
15. don't overreach. Keep proper footing and balance at all times.
16. maintain tools with care. Keep tools clean and in good working condition for maximum
safety performance. Follow instructions for lubricating and changing accessories.
17. disconnect tools before servicing – when changing accessories, such as blades, bits,
cutters, etc.
18. reduce the risK of unintentional starting. Make sure switch is in OFF position before
plugging in.
19. use recommended accessories. Consult the owner's manual for recommended accessories.
The use of improper accessories may increase risk of injury.
20. do not dry cut with blades designed for wet cuts.
21. maKe sure you use the correct blade for the job you are doing.
22. never stand on tool. Serious injury could occur if the wet saw is tipped or if the cutting tool
is unintentionally contacted.
23. checK damaged parts. Before further use of the tool, damaged part(s), (i.e., guard) should
be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and
any other condition that may affect the saw's operation. A guard or other part that is damaged
should be properly repaired or replaced.
24. ensure that there is a continuous flow of water to both sides of blade during
operation.
25. checK diamond blades carefully for cracKs, nicKs, missing diamond matriX or
out-of-alignment condition. Replace damaged blades immediately. do not use
damaged blades. They may cause bodily injury.
26. direction of feed. Feed work into the blade against the direction of rotation of the blade only.
27. do not alter the plug or use a 2-prong receptacle. This saw is equipped with a 3-prong
electrical plug.
28. never leave tool running unattended. Turn power off. Don't leave tool until it comes to a
complete stop.
- 3 -