Door Bins; Lights; Care And Cleaning; Cleaning - Jennair W11348447B Guide D'utilisation

DOOR BINS (SOLID DOOR MODELS)
Your refrigerator has two door bin locations for maximum
storage capacity.
TO REMOVE AND REPLACE THE DOOR BINS:
1.
Remove the door bin by tilting it forward and pulling
it out.
2.
Replace the bin by placing the rear of the bin under
the support on the door and sliding into place.

CLEANING

WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Clean the refrigerator once a month to avoid buildup of
odors. Wipe up spills immediately.
TO CLEAN YOUR REFRIGERATOR:
1.
Unplug refrigerator or disconnect power.
2.
Remove all shelves and bins from inside the
refrigerator.
3.
Hand wash, rinse, and dry removable parts and
interior surfaces thoroughly. Use a clean sponge or
soft cloth and a mild detergent in warm water.
To avoid damaging wooden tines and trim
pieces, wipe them off with a clean sponge or
soft cloth and warm water. Do not use detergent
or immerse the entire rack into water when
cleaning.
Do not use abrasive or harsh cleaners such as
window sprays, scouring cleansers, flammable
fluids, cleaning waxes, concentrated detergents,
bleaches or cleansers containing petroleum
products on plastic parts, interior and door liners
or gaskets. Do not use paper towels, scouring
pads, or other harsh cleaning tools. These can
scratch or damage materials.
To help remove odors, you can wash interior walls
with a mixture of warm water and baking soda (2
tbs to 1 qt [26 g to 0.95 L] of water).
4.
Wash stainless steel and painted metal exteriors with

CARE AND CLEANING

LIGHTS

The refrigerator has an interior light that illuminates
when the door is opened.
NOTE: The light is an LED which does not need to be
replaced. If the LED does not illuminate when the door is
opened, call Service. Refer "Assistance" section for contact
information.
a clean sponge or soft cloth and a mild detergent in
warm water. Do not use abrasive or harsh cleaners,
or cleaners containing chlorine. These can scratch or
damage materials. Dry thoroughly with a soft cloth.
NOTE: To keep your stainless steel refrigerator looking
like new and to remove minor scuffs or marks, it
is recommended that you use the manufacturer's
approved Stainless Steel Cleaner and Polish.
IMPORTANT:
This cleaner is for stainless steel parts only!
Do not allow the Stainless Steel Cleaner and
Polish to come into contact with any plastic parts
such as the trim pieces, dispenser covers or door
gaskets. If unintentional contact does occur, clean
plastic part with a sponge and mild detergent in
warm water. Dry thoroughly with a soft cloth.
5.
Replace the shelves and bins.
6.
Clean the condenser coils regularly. They are located
behind the base grille. Coils may need to be cleaned
as often as every other month. This may help save
energy.
Remove the base grille to access
cleaning. Refer "Removing Base Grille" section.

REMOVING BASE GRILLE

You must remove the base grille to access the condenser
coils for cleaning.
TO REMOVE THE BASE GRILLE:
1.
Open the refrigerator door.
A. Screws
condenser for
A
13