Publicité
Les langues disponibles
Les langues disponibles
A
- The direct discharge of the fuel products must be at roof and is forbidden to confined spaces, even with
clear sky.
-
With the installation type B of the stove sealed the technician must turn off the air flow sensor and reset
the parameters of the stove.
- The installation must be performed by qualified personnel, who will assume full responsibility for the
installation and its operation of the installed.
2.5 Brazier and baffle position check
Before lighting the stove make sure the brazier is in the correct position, i.e. fitted in the special slots. Also make
sure the top smoke baffle is properly fitted. A wrongly positioned baffle can result in malfunctioning and excessive
blackening of the glass.
At every stove lighting, check the correct position of the brazier on the brazier holder.
2.6 Electrical connection
Connect one end of the power cable to the rear socket of the stove, and the other to the wall socket.
The voltage supplied by the system must match that specified on the stove dataplate and in the technical data
section of this manual.
During stove idle periods it is advisable to remove the power cable.
- Make sure the electrical system is equipped with an earth and differential switch in accordance with the
current Regulations.
- The power cable must never touch the stove exhaust pipe.
AIR
37
AIR
B
VISION ERMETICA
Publicité
