LENCO PA-30 Mode D'emploi page 10

- Press the "Source" Button and select LINE.
LINE will show on the red LED display.
- Plug in your 3.5mm cable into the LINE
Input on the back panel and the unit will
enter into LINE IN mode.
- You can connect any audio device that has
3.5mm audio output jack and playback any
audio from the connected device.
RECHARGING
- Unit comes with a battery indicator alert.
- If Battery LED flashes, it means the battery level is low and recharging is required.
- By connecting the AC power, the Battery LED will turn red, it means the unit is under
recharging.
- When the Battery LED becomes green, it means the battery is fully charged.
It is recommended to charge the battery about 6 hours before you start using
the unit for the first time.
Caution: To keep the rechargeable battery in good condition, users should check
the unit and be sure to turn the Power On/Off switch on the back panel to "Off" every
time after using and before storage, it is highly recommended that users should fully
recharge the battery at least once every two months.
SING-A-LONG
- This product allows you to sing-a-long with
the songs that are playing either on BT,
USB or LINE IN mode.
- Plug in your Microphone cable into the side
panel marked "MIC"
- Adjust the MIC Volume "MIC +/MIC -" or
main volume on the top control panel.
- Adjust the Echo level "ECHO +/ECHO -".
- Start to sing
WARNING: - If the MIC Volume and
ECHO level set too high or to the
maximum, be caution with the high
pitch reflection tone.
SOUND EFFECTS
8