Fagor CO-502 Instructions D'installation Et D'utilisation page 41

Unsatisfactory wash.
Dishes and kitchenware
are not dry.
Scratches or stains on
dishes.
Machine stops during
operation.
Machine stops and fills
with water when it is
washing.
The machine does not
start with the wash cycle.
Machine does not drain
completely.
NOTE: If a fault occurs and is not listed in the above table, please call the
technical service. The manufacturer reserves the right to modify the
technical characteristics with prior warning.
Wash distributors obstructed.
Shortage of detergent.
Dirty filters.
Presence of foam.
Temperature of lower tub at 50
⁰C / 122 ⁰F.
Length of cycle too short for
level of dirt on dishes.
Water too dirty.
There is no rinse aid
Rinse aid low.
Dishes left inside dishwasher
for too long.
Rinse temperature lower than
80 ⁰C / 176 ⁰F.
Too much rinse aid.
Water too chalky.
Not enough salt in salt deposit.
Traces of salt in tub.
Electrical installation
overloaded.
Machine protection has tripped.
Pressure switch pipe blocked.
Pressure switch faulty.
Overflow incorrectly mounted.
Door is not closed properly.
Door micro switch faulty.
Machine not levelled correctly.
Pressure switch faulty.
Clean distributors thoroughly.
Call the technical service to reset the dispenser.
Clean the filters thoroughly.
Unsuitable detergent. Call the technical service to
supply correct detergent.
Too much rinse aid. Call the technical service to reset
the dispenser.
Thermostat faulty or incorrectly set. Call the technical
service to repair it.
Select a longer cycle.
Drain the wash tub and fill with clean water.
Fill the rinse aid container.
Call technical service to adjust dispenser.
When the dishwasher finishes, remove the basket
from the machine and allow to dry naturally.
Call technical service to analyse problem.
Call technical service to adjust rinse aid dispenser.
Check water hardness and if possible run
regeneration cycle immediately.
Fill salt deposit where applicable.
When filling the salt deposit, take care not to spill salt
in the tub.
Call technical service to modify electrical installation.
Reset safety device and if it trips again, call technical
service.
Empty the tub and clean thoroughly.
Call the technical service to replace it.
Mount overflow correctly.
Close the door correctly and if it is seen to re-open
alone, call the technical services to adjust the
tensioneers.
Call the technical service to replace it.
Level the machine In the event of doubt, please
contact your technical service.
Call the technical service to replace the pressure
switch.
41