Specifications; Fcc Information; Warranty - Beurer BG 40 Mode D'emploi

Masquer les pouces Voir aussi pour BG 40:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Display

11. Specifications

Batteries
Weight Limits
Working environment
Storage environment
Protection against ingress of water
CLASSIFICATION
1. Internally powered equipment;
2. Type BF applied part;
3. IP21;
4. Not intended to be sterilization or disinfection;
5. Not AP / APG equipment;
6. Mode of operation: continuous;

12. FCC Information

IMPORTANT INFORMATION REQUIRED BY THE FCC
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio fre-
quency energy, and if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

13. Warranty

Limited Lifetime Warranty For Original Purchaser
Your Beurer glass body analysis scale, Model BG 40, excluding the battery, is warranted to be free from
defects in materials and workmanship for the life of the product under normal conditions of intended use
Cause
The scale batteries are almost
flat.
Scale zero setting is incorrect.
Self test.
3 x AAA 1.5V batteries
11 lb to 330 lb (5 kg to 149.7 kg/11 lb to 23 st:8.7 lb)
5 °C to 40 °C (41 °F to 104 °F),
<= 90% RH, 80 kPa to 106 kPa
-20 °C to + 60 °C (-4 °F to 140 °F),
<= 93% RH, 50 kPa to 106 kPa
IP21
10
Solution
Replace the batteries of scale.
Wait until the scale switches itself off.
Now correctly activate scale, wait for
"0.0 lb" to appear and repeat measure-
ment.
Place scale on an even, hard surface and
wait for "0.0 lb" to appear.

Publicité

Table des Matières
loading

Table des Matières