DeWalt DWE4214 Guide D'utilisation page 10

English
Fig. D
11
13
Flanges and Wheels

CAUTION: Turn unit off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories.
Mounting Non-Hubbed Wheels (Fig. E)

WARNING: Failure to properly seat the flanges and/or
wheel could result in serious injury (or damage to the
tool or wheel).

CAUTION: Included flanges must be used with
depressed center Type 27/42 grinding wheels and
Type 1/41 cutting wheels. See the Accessories Chart
for more information.

WARNING: A closed, two-sided cutting wheel guard
is required when using abrasive cutting wheels or
diamond coated cutting wheels.

WARNING: Use of a damaged flange or guard or fail-
ure to use proper flange and guard can re sult in injury
due to wheel breakage and wheel contact. See the
Accessories Chart for more information.
1. Place the tool on a table, guard up.
2. Install the unthreaded backing flange
with the raised center (pilot) facing the wheel.
3. Place wheel 14 against the backing flange,
centering the wheel on the raised center (pilot) of the
backing flange.
4. While depressing the spindle lock button and with the
hex depressions facing away from the wheel, thread the
threaded locking flange
4
engage the two slots in the spindle.
5. nOTE: If the wheel you are installing is more than 1/8"
(3.17 mm) thick, place the threaded locking flange on
the spindle so that the raised section (pilot) fits into the
center of the wheel. If the wheel you are installing is
1/8" (3.17 mm) thick or less, place the threaded locking
flange on the spindle so that the raised section (pilot) is
not against the wheel.
8
12
7
3 on spindle 1
on spindle so that the lugs
Fig. E
Over 1/8" (3.17 mm)
wheels
Locking flange
Backing Flange
6. While depressing the spindle lock button, tighten the
threaded locking flange 4
- Tighten standard threaded locking flange using
a wrench 15 .
7. To remove the wheel, depress the spindle lock button
and loosen the threaded locking flange.
Fig. E 15
4
14
3
1
Mounting Sanding Backing Pads (Fig. F)
nOTE: Use of a guard with sanding discs that use backing
pads, often called fiber resin discs, is not required. Since a
guard is not required for these accessories, the guard may or
may not fit correctly if used.

WARNING: Failure to properly seat the clamp nut
and/or pad could result in serious injury (or damage
to the tool or wheel).

WARNING: Proper guard must be reinstalled for
grinding wheel, cutting wheel, sanding flap disc,
wire brush or wire wheel applications after sanding
applications are complete.
1. Place or appropriately thread backing pad
the spindle.
2. Place the sanding disc 17
3. While depressing spindle lock button
sanding clamp nut 18 on spindle, piloting the raised
hub on the clamp nut into the center of san ding disc
and backing pad.
4. Tighten the clamp nut by hand. Then depress the
spindle lock button while turning the sanding disc until
the sanding disc and clamp nut are snug.
5. To remove the wheel, grasp and turn the backing
pad and sanding pad while depressing the spindle
lock button.
1/8" Or less (3.17 mm)
wheels
Locking flange
Backing Flange
:
16 on
on the backing pad 16 .
2 , thread the