Num'axes CANICOM 5.201 Guide D'utilisation page 26

● button: vibrations (pager)
If you press the button, the receiver collar will emit vibrations. The collar will continue to vibrate for as long
as the button is pressed but no more than 8 seconds maximum.
If you press the button for more than 8 seconds, the collar will automatically go into safety mode for a few
seconds before restarting itself normally.
It's up to you to use the vibrations depending on the way you want to train your dog.
With the vibrations you can:
- send a warning to your dog when it is disobedient,
- draw its attention ...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
● button: static stimulations
If you press the button, the collar will emit static stimulations. Those stimulations are transmitted by the two
contact points located on the receiver collar for as long as the button is pressed but no more than 8 seconds
maximum.
If you press the button for more than 8 seconds, the collar will automatically go into safety mode for a few
seconds before restarting itself normally.
button: programmable booster
●
Press the button to stop your dog instantaneously.
You can choose the level of stimulation you think to be the best for an immediate effect. As a result, you do not
+
need to press the button.
The static stimulations are transmitted by the two contact points located on the collar for as long as the button is
pressed but no more than 8 seconds maximum.
If you press the button for more than 8 seconds, the collar will automatically go into safety mode for a few
seconds before restarting itself normally.
The stimulation level selected thanks to the
Programming the
- Activate the remote control
- Select the collar Nr 1 (for CANICOM 5.201 you don't have to select a collar)
-
- Press the button for approximately 5 seconds until the stimulation level flashes on the LCD screen
button for the collar Nr 1 (collar with orange strap):
Gb - 26
button can be different for each collar.