Num'axes CANICOM 5.201 Guide D'utilisation page 24

 Activate/deactivate the collar with the remote control
A magnet located in the remote control allows you to either switch On or Off the receiver collar.
- Activate: move the remote control towards the collar so that the magnet position indicator on the
remote control comes into contact with the
The indicator light on the collar will flash in green indicating the collar is On.
- Deactivate: move the remote control towards the collar so that the magnet position indicator on
the remote control comes into contact with the
The indicator light on the collar flashes from green to red then goes out indicating the collar is Off.
If you have several collars, renew the same procedure for each one.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long
period.
● Coding of the remote control with the receiver collar
Each remote control has its own individual radio operator code.
The coding of the remote control with the receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding procedure, make sure no other person is using his CANICOM 5
or other products from the NUM'AXES range close by. Your receiver collar could accidentally record the
code of his remote control. If that occurs, re-code the remote control with the receiver collar.
CODING PROCEDURE
WARNING: if you have several collars, you have to code them one at a time.
1. Activate the remote control: press for 1 second the On/Off button
2. Select the collar you want to code using the
- On the CANICOM 5.202, CANICOM 5.500 and CANICOM 5.800 remote controls, the symbol
appears on the LCD screen.
Gb - 24
symbol located on the collar for 1 second (ref. Diagram 6).
symbol located on the collar for 1 second (ref. Diagram 6).
Activate/deactivate the receiver collar
‹ or › button of the remote control.
Diagram 6
with the remote control
located on the remote control.
or