Skil PWRCORE 12 Guide D'utilisation page 15

Installing and Removing
Accessories
WARNING
pack before assembling parts .
WARNING
ries . Accessories become hot after prolonged
use, and the sharp edges of the accessories
will cause personal injury.
WARNING
tached . Incorrect or insecurely attached acces-
sories can come loose during operation and
cause a hazard.
To install the accessory (Fig .6)
a. Make sure that the ON/OFF switch is in the
OFF position and remove the battery pack.
b. Turn the clamping lever counterclockwise
about 140° until an audible "click" signals
that the lever has been fully engaged to
unlock the clamp mechanism.
c. Rotate the locking rod 90° clockwise, and
then pull out the locking rod.
d. Ensure that the locking rod and the
drive shaft are clean before installing the
accessory.
e. Position the accessory on the drive shaft,
making sure that all the grooves on the
accessory align with the ribs on the drive
shaft.
f. Insert the locking rod into the drive shaft,
then press the locking rod and rotate it 90°
counterclockwise so that it is secured in the
drive shaft.
g. Turn the clamping lever clockwise. An
audible "click" will signal that the lever has
been fully engaged to lock the clamping
mechanism. After hearing the click, continue
to turn the lever until it returns to its original
position.
Always turn the tool off
and remove the battery
Wear protective gloves
when changing accesso-
Check that the accesso-
ries are correctly at-
Fig. 6a
Fig. 6b
Fig. 6c
o
140
o
90
15