Skil PWRCORE 12 Guide D'utilisation page 14

Halo Light
Your tool is equipped with a Halo light, located
on the head of the tool. This provides addition-
al light without shadows on the surface of the
work piece for operation in lower-light areas.
The Halo light will automatically turn on when
the on/off switch is in "ON" position, and off
when the on/off switch is in "OFF" position.
(Fig.5)
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the halo light will flash rapidly.
Rest the tool for a while or place the tool and
battery pack separately under air flow to cool.
The Halo light will flash more slowly to indicate that the battery is at low-battery capacity. Re-
charge the battery pack.
14
Fig. 5
Halo light