Maintenance; Troubleshooting - Skil PWRCORE 20 Guide D'utilisation

MAINTENANCE

WARNING
Service
WARNING
cause serious hazard.
Service Center or Authorized SKIL Service
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.

TROUBLESHOOTING

Problem
Tool does not work.
Strong vibration or
loud noise during
operation.
LED Worklight
rapidly flashes.
20
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
We recommend that all tool service be performed by a SKIL Factory
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air.
wear safety goggles when cleaning tools with compressed air.
Certain cleaning agents and solvents damage plastic parts.
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery pack is depleted.
2. Battery pack is not installed
properly.
3. Burned out switch.
Accessory is not installed
securely.
1. Tool is over-loaded.
2. Tool is over-temperature.
Station.
1. Charge the battery.
2. Confirm battery is locked and
secured to the tool.
3. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
Reinstall the accessory according to
"Installing and Removing Accessories"
1. Release the trigger switch.
2. Cool the tool under air flow.
Always
Some of
Remedy