Skil PWRCORE 20 Guide D'utilisation page 13

LED Light (Fig. 5)
Your tool is equipped with an LED light, locat-
ed on the head of the tool. This provides addi-
tional light on the surface of the work piece for
operation in lower-light areas.
The LED light will automatically turn on when
the on/off switch is in "ON" position, and off
when the on/off switch is in "OFF" position.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off, and the LED light will flash
rapidly to indicate the over-load or
over-temperature condition.
Rest the tool for a while or place the tool and
battery pack separately under air flow to cool.
Installing and Removing
Accessories
WARNING
pack before assembling parts.
WARNING
ries. Accessories become hot after prolonged
use and the sharp edges of the accessories
can cause personal injury.
WARNING
attached. Incorrect or insecurely attached
accessories can come loose during operation
and cause a hazard.
To install the accessory (Fig.6a and Fig.6b)
a. Make sure that the ON/OFF switch is in the
OFF position and remove the battery pack.
b. Loosen the Clamping Screw with washer
with the hex key provided (Fig.6a).
c. Ensure that the inner threads and the
drive shaft are clean before installing the
accessory.
d. Position the accessory on the drive shaft,
making sure that all the grooves on the
accessory align with the ribs on the drive
shaft.
e. With your gloved hand holding the blade, put
the Clamping Screw with washer into the tool
and tighten it with the hex key (Fig. 6b).
Always turn the tool off
and remove the battery
Wear protective gloves
when changing accesso-
Check that the accesso-
ries are correctly
Fig.5
Fig.6a
Fig.6b
13