Maintenance; Troubleshooting - Skil PWRCORE 12 RI574501 Guide D'utilisation

Maintenance

WARNING
Service
WARNING
cause serious hazard. We recommend that all tool service be performed by a SKIL Factory
Service Center or Authorized SKIL Service Station.
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch selectors must be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.

Troubleshooting

Problem
Tool will not start.
Bit cannot be installed.
To avoid serious personal injury, always remove the battery pack from
the tool when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air. Always
w ear safety goggles when cleaning tools with compressed air.
Certain cleaning agents and solvents damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
1. Battery pack is depleted.
2. Tool is over-loaded.
3. Battery pack is over-
temperature
4. Battery pack is not installed
properly.
5. Burned out switch.
1. Sleeve is not released.
2. Bit does not fit the sleeve.
Cause Remedy
1. Charge the battery.
2. Release the variable-speed
trigger switch and try again.
3. Turn off the impact driver and
cool the battery pack under
air flow.
4. Confirm battery is locked and
secured to the tool.
5. Have the switch replaced by
an Authorized SKIL Service
Center or Service Station.
1. Release the sleeve.
2. Use suitable adapter.
15