Skil PWRCORE 20 Guide D'utilisation page 15

Using with Sanding Pad and
Sandpaper (Fig. 9)
WARNING
–
Always wear safety goggles or safety
glasses with side shields during power
tool operation. If the operation is dusty,
also wear a dust mask.
–
Wear protective gloves.
a. Align the sandpaper with the sanding pad
and use your hand to press it firmly onto the
sanding pad (Fig. 9a).
b. It is recommended that you sand a test
sample of the workpiece first to select the
best sanding paper for your job.
c. Select a high-speed range when sanding
with the multi-tool.
d. Allow the tool to reach its full selected speed
before allowing it to contact the workpiece.
Press the power tool with the sanding pad
firmly against the workpiece. This provides
for good adhesion and prevents premature
wear.
e. Work with the entire surface of the sanding
pad and sanding paper, not just the tip.
When one tip or corner of the sanding paper
is worn, it can be removed, turned 120°, and
reattached.
f. Sand the workpiece in a continuous motion
with moderate pressure. Excessive pressure
does not increase the rate of removal. It will result in unwanted sanding marks and cause
the sanding paper to wear more quickly. It can also cause tool overload (FIG. 9b).
Fig.9a
Fig.9b
15