Operating Instructions - Skil PWRCORE 20 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
in fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawa-
ter, certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a
short circuit.
WARNING
could result in serious personal injury.
WARNING
cation is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
assembling parts, making adjustments, or cleaning the tool.
This cordless multi-tool must be used only with the battery packs and charger listed
below:
2Ah
SKIL BY519701
NOTICE: Please refer to the charger and battery manuals for detailed operating information.
To Attach/Detach Battery Pack
(Fig. 2)
Make sure that the ON/OFF switch is in the
"OFF" position when attaching or detaching the
battery pack.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
NOTICE: When placing the battery pack on the tool, be sure that the raised rib on battery
pack aligns with the groove in the tool and that the latches snap into place properly. Improper
attachment of the battery pack can cause damage to internal components.
CAUTION
use or carrying it at your side.
To reduce the risk of fire, personal injury, and product damage due
to a short circuit, never immerse your tool, battery pack, or charger
If any parts are damaged or missing, do not operate this product until
the parts are replaced. Use of this product with damaged or missing parts
Do not attempt to modify this multi-tool or create accessories not
recommended for use with this multi-tool. Any such alteration or modifi-
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the multi-tool when
Battery Pack
4Ah
SKIL BY519601
Battery tools are always in operating condition. Therefore, the ON/
OFF Switch should always be in OFF position when the tool is not in
5Ah
SKIL BY519603
Fig. 2
Detach
Charger
SKIL SC535801
Attach
Battery-release
Button
11