Publicité
Les langues disponibles
Les langues disponibles
Operation
4 Operation
Once you have set up your baby monitor, you will be able to hear the sounds in your baby´s room
through the parent unit. You will also be able to see those sounds as the green sound sensor lights
around the top of the parent unit, which rise and fall with the volume level.
a
Note: If the connection between the parent unit and baby unit is broken at any time the green
"Link" light on the parent unit will flash and the green sensor light will cease to react to any
sounds. To re−establish the "Link", follow the directions in the "Troubleshooting" chapter.
Powering on/off the baby monitor
After having connected the baby monitor you will have to switch on both units. Press the On/Off key
on each unit. To switch off the unit press and hold down the On/Off key.
Volume
You can adjust the volume at which you hear your baby by using the keys ▲ and ▼ on the parent
unit. This will not effect the sensitivity of your baby monitor, only the volume at which you hear those
sounds through the parent unit.
Battery charge indicator and battery low warning
The parent unit will work up to 10 hours out of the charger pod, but this depends on the level of
charge in the batteries. The charge level is indicated by the battery icon on the Display. If the charge
becomes low, a "battery low warning beep" will sound and the battery icon on the parent unit´s
Display will begin to flash. If this occurs you should return the parent unit to the charger pod to
re−charge the batteries. You can still use your parent unit from the charger pod.
On the display you can see the charging status:
Battery icon filled
Battery icon 2/3 filled
Battery icon 1/3 filled
Battery icon not filled / frame flashes
Sound alert
You can set your parent unit to give an extra warning "beep" should the noise levels in your baby's
room activate the light on the sound sensor. This is particularly useful if the volume of your parent
unit is turned down and you are just using the sensor light to monitor the noise levels in your baby's
room.
Parent to parent paging
Useful if one parent is in the baby's room and needs to contact the other. Also helps to find a mislaid
parent unit.
At the baby unit
Press and hold the Page Key for 2 seconds. The parent unit will emit a tone. The tone can be swit-
ched off by pressing any key on the parent unit or by pressing the page key on the baby unit once
again.
Night light
The baby unit has a night light which emits a soft starry glow, providing comfort and re−assurance
for your baby and allowing you to see them in a darkened room. You may also turn the night light on
and off from the parent unit.
34
= full capacity
= approx.half capacity
= batteries nearly exhausted
= batteries must be charged
Publicité
