Télécharger Imprimer la page

Coleman 5178 Série Notice D'emploi page 5

Lanternes à propane

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect propane cylinder and lantern propane
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
Match Light
Lantern
■ Push lighted match
through lighting hole,
hold near mantle and
open fuel valve fully.
(Fig. 12)
Fig. 12
WARNING
• BURN HAZARD
• Never leave lantern unattended when hot or
in use.
• Keep out of reach of children.
NOTE: If lantern does not
light, repeat above step. If
the lantern does not light
after several attempts,
check for a spark while
clicking the igniter. If no
spark is present, check
the electrode gap. The
gap should be about .2"
(5 mm). (Fig. 14)
Carefully bend electrode
to set gap. If the lantern is wet due to rain, high
humidity, etc., the electrode may not spark. Use
lighting procedure for match light version lanterns.
■ Brightness may be
adjusted with
fuel valve. (Fig. 15)
INSTASTART ™
Electronic
Ignition Lantern
■ Open burner valve
and repeatedly push
igniter button and
ignite the mantles.
(Fig. 13)
Fig.13
.2"
(5 mm)
Fig. 14
Fig. 15
English-4
To Turn Off
■ Turn fuel valve off.
(Fig. 16)
To Store
■ Make sure lantern
is cool.
■ Move lantern away
from flame (including
pilot lights) and other
ignition sources.
■ Remove propane
cylinder from lantern.
(Fig. 17)
■ Replace protective
cap on propane
cylinder.
■ Lantern must
be placed in
base for secure
storage. (Fig. 18)
DANGER
• EXPLOSION - FIRE HAZARD
• Never store propane near high heat, open
flames, pilot lights, direct sunlight, other igni-
tion sources or where temperatures exceed
120 degrees F (49°C).
• The cylinder must be disconnected when the
lantern is in storage.
Fig. 16
Fig. 17
Fig. 18

Publicité

loading