LENCO BT-130 Guide D'utilisation page 11

OTS80 BK3254 BT_AUX_20170919_r0_draft for MK
8. Disconnect the Audio cable when it is done.
L. Use Micro SD Card
1. Insert your Micro SD memory card into speaker's memory card slot;
make sure that the memory card is firmly and correctly inserted.
2. Power On the device, the "MODE Indicator (1)" will switch to blink
red from current color;
3. It is in Micro SD Card playback mode and the music will play in second
automatically.
4. The device also provide last track memory playback function, which
allow to playback the last track where you escape when every time
you switch back to Micro SD/TF Card playback mode.
Remark: The last track memory function will correct and use new track
data if last inserted Micro SD/TF memory card has changed to other card.
M. Change Modes
1. Short press the "
mode to next mode if SD memory card and or AUX IN cable are in
place.
2. Each press the "
"AUX IN" repeatedly for example.
N. Low Power Reminder And Power Off
1. The Bluetooth Speaker will send tones sound from speaker by every
minute. When you heard this reminder sound, please connect the
device with USB power for charge if you still want to use the device.
2. If not, the Bluetooth Speaker will power off automatically when the
battery is keeping low energy level in some minutes.
3. In this case, the device cannot be turned on, until you recharging the
battery at least 10 ~ 15 minutes, because the rechargeable battery
has not enough energy.
4. Short press the "
with enough energy if you want.
(4)" button can switch mode from current using
(4)" button can mode from "Bluetooth" > "SD/TF" >
(4)" button to turn on the device after charged
11