Main Area Of Application; Technical Data; Paint Material Setup; Textured Material Setup - Titan IMPACT 1640 Mode D'emploi

MAIN AREA OF APPLICATION

2
MAIN AREA OF APPLICATION
This airless sprayer is a precision power tool used
i
for spraying many types of materials including
textured products from a ready-mixed or
powdered formulation.
Read and follow this instruction manual carefully
for proper operating instructions, maintenance,
and safety information.
2.1

TECHNICAL DATA

Gallons per minute (GPM)
Maximum tip size
Maximum pressure
Power
Weight
Maximum hose length
Generator requirement
2.2

PAINT MATERIAL SETUP

This sprayer comes with a filter assembly
i
installed. If you plan to spray with untextured
painting materials, leave the filter installed.
8
1.3 (4.9 LPM)
1 gun - 0.039"
2 gun - 0.025"
3300 PSI (22.8 MPa)
3.6 HP Brushless DC Motor,
220~230V AC, 50/60Hz, 12A
110 lbs. (50 kg)
300' (91.4 m)
5000 Watt, 20A, sine wave
generator, idle-down feature
disabled
2.3

TEXTURED MATERIAL SETUP

This sprayer comes with a filter plug that should
i
be put in place of the filter whenever spraying
textured materials. Follow these steps to remove
the filter and install the plug.
1. Loosen and remove the filter housing (Fig. 1, item 1) by
hand.
2. Remove the adapter spring (2), filter (3), bearing ring (4)
and spring (5) from the housing (7).
3. Make sure the O-ring (6) is still in place. Thread the filter
plug (8) into the housing until secure.
The filter plug should be hand-tightened, but
i
make sure it is seated fully into the filter housing.
1
2
3
4
5
If the sprayer will be used for spraying textured
i
products, removal of the inlet screen in the foot
valve may be necessary. This will allow proper
priming and flow of the textured product. See
section 6.4.
IMPACT 1640
8
6
7